What does Error Code P0746 mean?
Moderate Issue
DTC Code P0746 indicates a malfunction in the Pressure Control Solenoid 'A', where it is either underperforming or stuck off. This affects the transmission line pressure regulation, as the solenoid fails to adjust the pressure according to the Transmission Control Module (TCM) signals, leading to a mismatch between the required and actual gear.
What are the symptoms of Error Code P0746?
- Engine Light ON: The check engine light or service engine soon warning light illuminates, indicating a potential issue with the transmission system. This is often linked to the pressure control solenoid 'A' malfunction.
- Transmission Shift Shock: Drivers may experience a noticeable shock or jolt during gear shifts. This symptom is associated with the pressure control solenoid 'A' being stuck off or not performing as expected, affecting the smoothness of gear transitions.
What causes Error Code P0746?
- Low transmission fluid level can lead to insufficient hydraulic pressure, affecting solenoid performance.
- Dirty transmission fluid may cause blockages, preventing the solenoid from functioning correctly.
- A faulty line pressure solenoid valve can result in improper pressure regulation within the transmission.
- An open or shorted line pressure solenoid valve harness can disrupt electrical signals, impairing solenoid operation.
- Poor electrical connections in the line pressure solenoid valve circuit can lead to intermittent or failed solenoid activation.
Find the Root Cause with AI
Analyze symptoms and error codes with artificial intelligence for a precise diagnosis
Fast Diagnosis in under 3 minutes
Precise AI-powered analysis
Free No hidden fees
Data-Driven Over 40,000 reference cases
How to fix Error Code P0746?
- Initial Inspection: Check the transmission fluid level and condition. Ensure the fluid is at the correct level and is not dirty or contaminated. If the fluid is dirty, proceed with a fluid change.
- Transmission Fluid Change: If the fluid is dirty, replace it. Remove the transmission pan to inspect for debris or metal particles, which could indicate a mechanical failure.
- Visual Inspection of Solenoid: Inspect the pressure control solenoid 'A' for any visible signs of damage or obstruction. Ensure the solenoid is properly connected and there are no loose or damaged wires.
- Solenoid Function Test: Perform a solenoid function test using a scan tool to ensure the solenoid is operating correctly. Check for any electrical issues that might affect solenoid performance.
- Valve Body Inspection: Inspect the transmission valve body for any obstructions or damage that could affect fluid flow. Clean or replace components as necessary.
- Final Verification: After addressing any issues, clear the DTC code and perform a test drive to ensure the problem is resolved and the code does not return.