Car X-ray visualization

What does Error Code P0355 mean?

Moderate Issue
DTC Code P0355 indicates an issue with the Ignition Coil 5 Control Circuit in vehicles with a generic ignition system. This code is triggered when the Engine Control Module (ECM) detects a mismatch between the commanded and actual state of the ignition control circuit for coil 5, affecting the spark event.

What are the symptoms of Error Code P0355?

  • Engine Light ON: The check engine light or service engine soon warning light illuminates, indicating an issue with the ignition coil 5 control circuit.
  • Lack/Loss of Power: The vehicle may experience a noticeable reduction in power, potentially linked to a malfunctioning ignition coil affecting cylinder performance.
  • Engine Harder to Start: Starting the engine may become more difficult due to improper ignition timing or spark delivery from the faulty coil.
  • Engine Hesitation: The engine may hesitate during acceleration, which can be attributed to inconsistent spark delivery from the affected ignition coil.
  • Rough Engine Idle: The engine may idle roughly, possibly due to misfires caused by the ignition coil 5 control circuit issue.

What causes Error Code P0355?

  • The ignition coil may be defective, leading to improper spark generation and engine misfires.
  • There could be an open or short in the wiring harness connected to Ignition Coil 5, disrupting the electrical flow.
  • Poor electrical connections in the circuit can cause intermittent or weak signals to the ignition coil.
  • The Engine Control Module (ECM) might be malfunctioning, failing to send the correct signals to the ignition coil.
MechanX

Find the Root Cause with AI

Analyze symptoms and error codes with artificial intelligence for a precise diagnosis

Fast Diagnosis in under 3 minutes
Precise AI-powered analysis
Free No hidden fees
Data-Driven Over 40,000 reference cases

How to fix Error Code P0355?

  • Initial Inspection: Inspect the ignition coil for Cylinder 5 for any visible damage or corrosion. Check the wiring and connectors for signs of wear or disconnection.
  • Check Power Supply: Use a multimeter to verify that the ignition coil is receiving the correct voltage. Ensure the power supply to the coil is within the manufacturer's specifications.
  • Test Coil Resistance: Measure the resistance of the ignition coil using an ohmmeter. Compare the readings with the manufacturer's specifications to determine if the coil is functioning properly.
  • Inspect Control Circuit: Examine the control circuit for any open or short circuits. Use a wiring diagram to trace the circuit and ensure continuity.
  • ECM/PCM Check: Verify that the Engine Control Module (ECM) or Powertrain Control Module (PCM) is sending the correct signals to the ignition coil. Use a scan tool to monitor the signals and ensure they match the expected values.
  • Swap Test: If the issue persists, swap the ignition coil with another cylinder's coil to see if the problem follows the coil. This can help determine if the coil itself is faulty.
MechanX